!=program, 1=list number 1, 0=list row number 0, 2=execute Which define the key to trigger ( data1=97 as per keyboardĬommands to execute when the PC-is-OFF (that is state 0):Ĭommands to execute when the PC-is-ON (that is state 1): Index, 8=Gamepad Key, 9=Gamepad Axis, 10=Gamepad Rotation Axis,Ī maximum of three comma separated values follow the command,
The command ( cmd) is what type of deviceġ=system key, 2=keyboard, 3=type string, 4=consumer key,ĥ=delay in milliseconds, 6=delay in seconds, 7=change list 'PC-is-ON' and no commands have been defined for the state Only one command ( idx 0) has been defined for the state The button uses a command list/table with rows that it willĮxecute one after the other. If you want to use the codes from the HID usage, table you need As you can see in this keyboardĬodes list, the keyboard code for key 'a' is decimal 97įor all codes please refer to the HID usage table p.53ff.
#INSTALL AND USE COOLTERM SERIAL#
(If it does not appear, check your serial connection/ choose another COM port): Every command string sent to the button must be transmitted with a semicolon.Īfter sending "h " to the button, the firmware should appear as follows Start CoolTerm, click on 'Options', choose COM port and baudĪfter clicking Connect, send h to the buttonįor help.If the GNU screen does not work for you, download CoolTermLinux.zip.
#INSTALL AND USE COOLTERM INSTALL#
If the screen command is not installed, type: "sudoĪpt-get install screen" for a common debian based linux.(type screen /dev/ttyA" and then TAB key). Open terminal and enter: sudo screen /dev/ttyACM0.Start CoolTerm, click on 'Options', choose the COM port and baud.
If the GNU screen does not work for you, download CoolTermMac.zip (Mac).Then TAB key to see the connected tty pushbutton devices). dev/tty.usbmodemHIDA1 (type "screen /dev/tty." and If there is no reaction, choose another COM port in options and retry. Rate 115200 and click on 'Connect' and confirm with 'Ok'. Start CoolTerm.exe, choose "use defaults", then click on 'Options', choose the last COM port in the list and baud.If this is the case, please download and install the Arduino IDE manually and afterward proceed with manual installation as described in point 1. Check your device manager wether there is an Arduino Leonardo device with an exclamation mark (=no driver found).Click here to see a detailed manual installation description. Please wait until your operating has auto-installed the Arduino Leonardo drivers on first button plugin.First connect the button to your computer. The USB button can be configured to simulate pressing any keyboard
0 kommentar(er)
